NOTE: Virtual servers are not supported

 On the Old Mastercam server PC

• Unplug the Nethasp from the “old” Mastercam server PC
• Uninstall the license manager.

On the New Mastercam server PC

• Plug the Nethasp to the PC, make sure the light turns on, if not download the driver (see link) once installed the light will be on.
  • http://www.mastercam.com/en-us/Support-Downloads-Drivers-and-Applets
• Download and install license manager as a service.
  • http://www.mastercam.com/en-us/Support-Downloads-Drivers-and-Applets
• Then download the NhaspX utility this allows you to update your code and read the hasp.
  • http://www.mastercam.com/en-us/Support-Downloads-Drivers-and-Applets
• Open the NhaspX utility and read the hasp in local mode and in Network mode. If properly set up, you should be able to read in both modes.
• After reading it in Network mode click ok and close the utility.

Getting a client PC to read the NetHasp

• On the client PC launch Mastercam. It should launch, if you get a “No sim found” error open the Nethasp utility and try and read it in network mode, if you cannot please see below.
  • You may need to use a modified .ini file to point your client PC to the servers IP address
  • Download the following edited .ini file and replace the IP address in it for your Mastercam server PC’s IP address and save it here: C:\Program Files\Mastercam 20XX\Mastercam

Modified .ini file download: https://trimech.sharefile.com/d-sb0e2c93a3d85469a8743dc8107d52891